Lifting Of Loads - Abb A101-H Series Original Assembly Instructions

Assembly Instructions / A101-H
2 Safety / 2.2 Lifting of loads
2.2

Lifting of loads

WARNING
Suspended loads
Loads that are not attached according to regulations can cause injury to
personnel or fatal accidents.
Loads must always be fastened to properly functional lifting gear with a
u
sufficient load limit.
Pay attention to the correct attachment of loads on the crane hook.
u
People must not stand beneath suspended loads.
u
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Fig. 1: Attachment of loads on the crane hook
Fig. 2: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be ex-
ceeded. This prevents excessive loading due to diagonal pull.
Use a suitable edge guard if there are sharp edges.
u
The assembly devices must be completely screwed in and must not unscrew during use.
u
Use assembly devices only for the described applications.
u
© Copyright 2019 ABB. All rights reserved. HZTL455311P0038_EN Rev.A December 2019