Remote Control Panel; Specifications - Yamaha A-S201 Service Manual

A-S201

■ REMOTE CONTROL PANEL

6
RAS2

■ SPECIFICATIONS

■ Audio Section
Minimum RMS Output Power (Power Amp. Section)
(40 Hz to 20 kHz, 0.2 % THD, 8 ohms / L/R drive)
R, K, A, B, G models .................................................100 W + 100 W
T, L models ...................................................................85 W + 85 W
Dynamic Power Per Channel (IHF) [R, K, A, B, G models]
8 / 6 / 4 / 2 ohms .......................................... 125 / 150 / 165 / 180 W
Maximum Power Per Channel (1 kHz, 0.7 % THD, 4 ohms)
[B, G models]
................................................................................................ 115 W
Maximum Effective Output Power (JEITA)
(1 kHz, 10 % THD, 8 ohms) [R, T, L models]
R model .................................................................................. 140 W
T, L models ............................................................................. 125 W
Input Sensitivity/Input Impedance (1 kHz, 100 W/8 ohms)
PHONO (MM) .................................................. 10.0 mV / 47 k-ohms
CD etc. .............................................................. 500 mV / 47 k-ohms
Output Level/Output Impedance
REC OUT ......................................................... 500 mV / 2.2 k-ohms
Headphone Jack Rated Output/Output Impedance
(1 kHz, 500 mV, 8 ohms load / CD etc. input)
........................................................................... 470 mV / 470 ohms
Frequency Response (CD etc.)
20 Hz to 20 kHz ................................................................ 0 ±0.5 dB
10 Hz to 100 kHz .............................................................. 0 ±3.0 dB
RIAA Equalization Deviation
PHONO (MM) ...................................................................... ±0.5 dB
Total Harmonic Distortion (20 Hz to 20 kHz)
PHONO (MM) to REC OUT (2 V) ..............................0.025 % or less
CD etc. to SP OUT (50 W/8 ohms) ...............................0.2 % or less
Signal to Noise Ratio (IHF-A Network)
PHONO (MM)
Input shorted 10 mV ............................................... 75 dB or more
CD etc. (PURE DIRECT on)
Input shorted 500 mV ........................................... 100 dB or more
Residual Noise (IHF-A Network)
................................................................................................. 70 μV
Tone Control Characteristics
Bass
Boost/Cut (50 Hz) ............................................................... ±10 dB
Turnover frequency ............................................................. 170 Hz
Treble
Boost/Cut (20 kHz) ............................................................. ±10 dB
Turnover frequency ............................................................ 3.0 kHz