Table of Contents
Advertisement
14 APPENDIX 1 FOXTERM SETUP
14.1 FOXTERM INSTALLATION
These instructions refer to FoxTerm, but the
concepts are the same in all terminal emulators.
Download FoxTerm from www.foxterm.net.
Create a folder in "My Documents" called
"H2scan".
Unzip the FoxTerm files into the H2scan folder.
14.2 FOXTERM SETUP
Start FoxTerm
Close the default session window (if needed).
Open a new session window.
Select the correct port as determined above
(COM3 in this example).
Setup the session as shown below
Select a log file name and location. The file
name should start with the current date
(YYYMMDD) followed by any particular
information required. This way, the files will be
easy to sort. For example "20110920Yukon6.log"
would be the file name for the "Yukon6" sensor
that had logging started September 20th, 2011.
The ".log" extension is the default, but any
extension could be used.
Newline Behavior must be set to "CRLF".
Click OK.
Save the session as "H2scan.xml" in the
FoxTerm program location.
The setup should look similar to that shown.
90000012 R8
HY-ALERTA™ 1600, Intrinsically Safe Area Hydrogen Monitor
OPERATING MANUAL
Page 22 of 31
Advertisement
Table of Contents
