Operating The Dryer - Kenmore 796.6142 Series Use & Care Manual

HOW TO USE

OPERATING THE DRYER

CLEAN THE LINT FILTER
1
If the lint filter has not already been cleaned, lift out the filter
and remove the lint from the last load. This will help ensure the
fastest and most efficient drying performance.
Lint
Filter
LOAD THE DRYER
2
Load the dryer with the wet laundry from the washer. If the
load is extra large, you may need to divide it into smaller
loads for proper performance and fabric care.
TURN ON THE DRYER
3
Press the POWER button to turn ON the dryer. The cycle LEDs
will illuminate and a chime will sound.
SELECT A CYCLE
4
Press the desired cycle button to select a cycle. The standard
presets for the selected cycle will be shown in the display. On
MANUAL DRY cycles, these settings can be adjusted using the
cycle modifier buttons any time before starting the cycle.
NOTE: Not all options or modifiers are available on all
cycles. Refer to the cycle guide page for default settings and
allowable options. A different chime will sound and the LED
will not illuminate if the selection is not allowed.
BEGIN CYCLE
5
Press the START/PAUSE button to begin the cycle. The cycle
can be paused at any time by opening the door or by pressing
the START/PAUSE button. If the cycle is not restarted within four
minutes of being paused, the dryer will shut off and the settings
will be lost.
END OF CYCLE
6
When the cycle is finished, the chime will sound. Immediately
remove your clothing from the dryer to reduce wrinkling. If
WRINKLE GUARD is selected, the dryer will tumble briefly
every few minutes to help prevent wrinkles from setting in the
clothes.
22