Water Condensation Drainage - Honeywell HF Series User Manual

WATER CONDENSATION DRAINAGE

When there is excess water condensation inside the unit, the Local Air Conditioner stops running
and shows an error code "P1" with an alarm. This indicates that the water condensation needs to be
drained using the following procedures:
Manual Draining in Cooling, Dehumidifying and Auto Modes
Water may need to be drained in high humidity areas.
1. Unplug the unit from power source.
2. Place a shallow pan under the lower rubber drain plug.
See diagram.
3. Remove the drain plug cap.
4. Water will drain out and collect in the shallow pan.
5. After the water is drained, replace the drain plug cap.
6. You can now turn on the unit.
Continuous Draining for Dehumidifier Mode
While using the unit in dehumidifier mode, continuous drainage is recommended.
1. Unplug the unit from power source.
2. Remove the upper drain plug cap.
Some residual water may spill so please have a pan to
collect the water.
3. Connect the drain tube (included) to the upper drain
plug. See diagram.
4. The water can be continuously drained through the
drain tube into a floor drain or bucket.
5. Replace the drain plug cap.
6. You can now turn on the unit.
Drain Tube (included):
Dia. 0.6" (1.6 cm)
Length: 23.6" (60 cm)
EN 13
Lower
Rubber
Drain Plug
Shallow Pan
(not included)
Upper Rubber
Drain Plug