Approvals - Siemens CM 1542-1 Operating Instructions Manual

Approvals

Approvals issued
Note
Issued approvals on the type plate of the device
The specified approvals - with the exception of the certificates for shipbuilding - have only
been obtained when there is a corresponding mark on the product. You can check which of
the following approvals have been granted for your product by the markings on the type
plate. The approvals for shipbuilding are an exception to this.
Certificates for shipbuilding and national approvals
The device certificates for shipbuilding and special national approvals can be found in
Siemens Industry Online Support on the Internet:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15341/cert)
EC declaration of conformity
The product meets the requirements and safety objectives of the following EC directives and
it complies with the harmonized European standards (EN) for programmable logic controllers
which are published in the official documentation of the European Union.
● 2014/34/EU (ATEX explosion protection directive)
Directive of the European Parliament and the Council of 26 February 2014 on the
approximation of the laws of the member states concerning equipment and protective
systems intended for use in potentially explosive atmospheres, official journal of the EU
L96, 29/03/2014, pages. 309-356
● 2014/30/EU (EMC)
EMC directive of the European Parliament and of the Council of February 26, 2014 on the
approximation of the laws of the member states relating to electromagnetic compatibility;
official journal of the EU L96, 29/03/2014, pages. 79-106
● 2011/65/EU (RoHS)
Directive of the European Parliament and of the Council of 8 June 2011 on the restriction
of the use of certain hazardous substances in electrical and electronic equipment
The EC Declaration of Conformity is available for all responsible authorities at:
Siemens Aktiengesellschaft
Division Process Industries and Drives
Process Automation
CM 1542-1
Operating Instructions, 07/2019, C79000-G8976-C355-04
7
43