JVC KW-AVX830 Instructions Manual page 34

Sound
Menu item
Fader/Balance
Fader/Balance
Reset
Fader
Balance 0
Back Exit
Volume Adjust * 4
Subwoofer Level
High Pass Filter
Low Pass Filter
Amplifier Gain
Loudness
Rear Speaker * 5
* 4
For "DISC/USB": You can make the adjustments separately depending on the audio format—Dolby digital/MPEG
Audio and the others.
* 5
Only for KW-AVX830.
Selectable setting/item
Fader : Adjust the front and rear speaker output balance.
F6 to R6; Initial 0
♦
0
• When using a two-speaker system, set the fader to the center (0).
Balance : Adjust the left and right speaker output balance.
L6 to R6; Initial 0
♦
5 ∞ 2 3
Press [ / / /
• To clear the adjustment, press [Reset].
Adjust and store the auto-adjustment volume level for each source, comparing
to the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix> appears if an FM broadcast is selected as the source.
–12 to +12; Initial 00
♦
Adjust the subwoofer output level.
00 to 08; Initial 08
♦
Through : Select when the subwoofer is not connected.
♦
On : Select when the subwoofer is connected.
♦
Select the crossover frequency between the front/rear speakers and the subwoofer.
55Hz, 85Hz, 120Hz
♦
You can change the maximum volume level of this unit.
Off : Deactivates the built-in amplifier.
♦
Low : VOL 00 to 30 (Select this if the maximum power of the
♦
High : VOL 00 to 50
♦
• If you change the setting from <High> to <Low> while the volume level is set
higher than "VOL 30," the unit automatically changes the volume level to "VOL
30."
You can activate/deactivate the loudness function.
Off : Cancels.
♦
On : Boost low and high frequencies to produce a well-balanced
♦
You can activate/deactivate the rear speakers.
• This setting takes effect only when Dual Zone is activated. (
Off : Deactivate the rear speakers.
♦
On : Activate the rear speakers.
♦
] or drag [ ] to adjust.
speakers is less than 50 W.)
sound at a low volume level.
34
Initial: Underlined
27)