Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna PP 325 E Operator's Manual

Before starting

Make sure that:
• The machine is correctly connected to a suitable power
supply and correctly fused.
• The hoses have been connected to a device.

Starting

• Turn the switch to "START 5 SEC" in the direction
indicated by the lit lamp. The direction of rotation of the
engine will then be correct.
• Turn the switch to "RUN" after a few seconds.
• Open the tap to suitable water flow for the tool in question.
If the tool does not require water, cooling water should still
flow through the radiator, and then to the closest floor
drain.
10 –
English

STARTING AND STOPPING

Stopping

Switch off by turning the switch to "0".

After work is completed

• Disconnect the hydraulic hoses.
• If there is a risk of freezing, the machine must be drained
of any remaining water coolant. Disconnect incoming and
outgoing water hoses and tilt the machine forwards.