Installation Instructions; Transportation And Handling Before Installation; Installation Location Selection - Pioneer YH024GHFI18RT2 Installation Manual

Hide thumbs Also See for YH024GHFI18RT2:
Table of Contents

Advertisement

Installation Instructions

Transportation and Handling Before Installation

Transport the product as close to the installation location
as practical prior to unpacking.
·Recommended Transportation Method
When handling the unit, ensure a steady balance of the
unit, checking safety and lifting it up smoothly.
(1) Do not remove any packing materials.
(2) Hang the unit under packing condition with two ropes,
as shown in the Figure below.

Installation Location Selection

Prior to choosing the installation site, obtain all required approvals and select a location:
·That is not exposed to strong winds.
·Where airflow is sufficient and clean.
·Where it is not exposed to rains and/or direct sunshine.
·Where neighbors will not bothered by operation sounds or hot air being exhausted.
·Where rigid walls or support is available, to prevent the increase of operation sounds or vibrations.
·Where there is no risk of combustible gas leakage.
·Where it is at least 10 ft away from the antenna of a TV set or radio. An amplifier may be required for the
affected device.
·Install the unit horizontally and level.
·Install it in an area not affected by snowfall or blowing snow. If areas with heavy snow cannot be avoided,
install a canopy, a pedestal, and/or some baffle boards.
CAUTION:
Avoid the following places for installation where
air conditioner related issues are liable to occur.
·Where there is excessive machine oil.
·Salty locations, such as seasides.
·Where sulfide gas is generated, such as a hot spring.
·Where there is high-frequency or wireless equipment.
NOTE:
When operating the air conditioner in low outside temperatures, be sure to follow the instruction described below:
·Never install the outdoor unit in a place where its air inlet/outlet side may be exposed directly to winds.
·To prevent exposure to wind, install the outdoor unit with its air inlet side facing the wall.
·To prevent exposure to wind, it is recommended to install a baffle board on the air outlet side of the outdoor unit.
·Handling
If the unit has no protective packaging, protect it
instead using cloth or paper.
24K/36K: Over 12 in. (300mm)
60K: Over 24 in. (600mm)
4
Put Cloth or Paper

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yh036ghfi18rt2Yh060ghfi18rt2

Table of Contents