Removing The Rechargeable Battery; Warranty And Support; Troubleshooting - Philips 3000 Series Manual

Recycling
- Do not throw away the product with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this, you help to preserve the
environment.
- This product contains a built-in rechargeable
battery which shall not be disposed of with
normal household waste. Please take your
product to an official collection point or a
Philips service center to have a professional
remove the rechargeable battery.
- Follow your country's rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.

Removing the rechargeable battery

Only remove the rechargeable battery when
you discard the product. Before you remove
the battery, make sure that the product is
disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when
you handle tools to open the product and
when you dispose of the rechargeable battery.
1 Check if there are screws in the back or front of
the appliance. If so, remove them.
2 Remove the back and/or front panel of the
appliance with a screwdriver. If necessary, also
remove additional screws and/or parts until you
see the printed circuit board with the
rechargeable battery.
3 Remove the rechargeable battery.

Warranty and support

If you need information or support, please visit
www.philips.com/support or read the
international warranty leaflet.

Troubleshooting

This chapter summarizes the most common
problems you could encounter with the appliance.
If you are unable to solve the problem with the
information below, visit www.philips.com/support
for a list of frequently asked questions or contact
the Consumer Care Center in your country.
Problem
The
appliance
produces
an uneven
cutting
result.
The
appliance
does not
work when I
switch it on.
简体中文
简介
感谢您的惠顾，欢迎光临飞利浦！ 为了让您能充分享
受飞利浦提供的支持，请在 www.philips.com/welcome
上注册您的产品。
基本说明（图 1）
1 1-23 毫米修剪梳
2 1-23 毫米儿童修剪梳
3 修剪部件
4 长度设置调整滑块
5 开/关按钮
6 充电指示灯
7 电源部件
8 小插头
9 清洁刷
重要安全信息
使用产品之前，请仔细阅读本重要信息，并妥善保管以
供日后参考。
危险
- 保持电源部件干燥 (图 2)。
Possible
cause
The comb
does not
touch the skin
when you
move the
appliance
through the
hair.
You only
move the
appliance in
one direction.
The setting of
the comb has
changed
during
trimming.
The comb is
not
assembled
correctly.
The cutting
performance
decreases
when the
cutting unit
and the comb
are dirty.
The
rechargeable
battery is
empty
Solution
Make sure the
comb is always
fully in contact with
the skin when you
move the appliance
through the hair.
Because not all
hairs grow in the
same direction,
move the appliance
in different
directions
(upwards,
downwards and
across).
Check the setting
of the comb. If you
push the appliance
too hard onto the
scalp, you may
accidentally
change the setting
of the comb.
Detach the comb
and reattach it.
Clean the cutting
unit and the comb
(see 'Cleaning').
Charge the
appliance. Make
sure that the small
plug is inserted into
the appliance
properly and the
adapter is
connected to the
wall socket
properly.