Whirlpool 2180633 Use And Care Manual page 8

Changing the light bulb
Electrical Shock Hazard
Before removing the light bulb, either
unplug the ice maker or disconnect the
electricity leading to the ice maker at the
main power supply.
Shock and injury can occur if electricity
remains connected.
The ice maker has a light bulb in the top of
the storage bin. To replace it, open the bin
door and follow these instructions:
1. Disconnect ice maker from power supply.
2. Remove the two thumb screws and slide the
ice cutter grid forward, out of the two slots
near the water pan. Set the ice cutter grid on
the bin door.
3. Press the front of the light shield in while
pulling down to remove it from the light
bracket.
4. Remove and replace with a 12-volt wedge
base-type bulb (automotive #917).
5. Replace the light shield, ice cutter grid, and
two thumb screws.
6. Reconnect power supply.
8