Installation Manual
20002298
9. Install the gland body into the conduit opening on the core processor housing.
10. Insert the wires through the gland body and tighten the gland nut onto the gland
4.2.5
Connect the wires to the core processor terminals
After the 4-wire cable has been prepared and shielded (if required), connect the individual
wires of the 4-wire cable to the terminals on the core processor.
Procedure
1. Connect the wires to the core processor terminals.
Installation Manual
body.
A. Shield folded back
B. Gland body
•
If you are connecting to a standard core processor, use the following image and
connections:
A
B
A. Terminal 1 (Power supply +): Red wire
B. Terminal 2 (Power supply -): Black wire
C. Terminal 3 (RS-485/A): White wire
D. Terminal 4 (RS-485/B): Green wire
•
If you are connecting to an enhanced core processor, use the following image
and connections:
D
A A
C
Wiring
April 2020
17