Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ED25SMIII Use & Care Manual

Install properly.. .
Remove sales labels.. .
1. Allow % inch (1.25 cm) space on each side and at
the top of the refrigerator for ease of installation,
2. If the refrigerator is to be against a wall, you might
want to leave extra space so the door can be
opened wider
3. The refrigerator back can be flush against the wall.
m.wda I
I .I -i '_ >.
'< ,.
Level refrigerator-freezer.. .
Right to Raise;
Left to lower
I. Remove base grille [see page 7 ).
2. To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left.
4. Check with level.
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
1. Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetmchloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
* I. *+v I.?IyLW,I -wmmm"m,"&.C~*IIR*I ,r*-L* .I :,*1*:*=
Clean your refrigerator
before using it.
See cleaning instructions
on pagell,
Clean it.. .
3-prong grounding
type wall receptacle,
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4