Determine Cabinet Opening - Whirlpool TUD8700SQ Installation Instructions Manual

Wiring configuration
Power supply wire:
white
black
ground wire
If needed, see website for animated representation of
this step. Visit www.whirlpool.com under FAQ tab.
4
Power Cord—Secure cord
on conduit connector
Tighten conduit connector screws to secure cord.
5
Power Cord—Reinstall
terminal box cover
Place wires inside terminal box. Insert tabs on left side
of cover. Make sure wires are tucked inside box. Close
cover ensuring wires are not pinched. Use 1/4" nut
driver and previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed.
12
Terminal box wire:
white
black
ground connector

Determine Cabinet Opening

1
Measure cabinet opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed
(you will need to measure the lowest point on the
underside of the countertop and the highest point on the
floor). Refer to "Dishwasher Height Adjustment Chart"
for wheel position and the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet Wheel
opening height position
33-7/8" (86.0 cm) Removed
34" (86.4 cm)
34-1/4" (87 cm)
34-1/2" (87.6 cm)
NOTE: If the minimum cabinet opening height is less than
34"(86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 33-7/8" (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset at the
factory for 34-1/2" (87.6" cm).)
2 Adjust wheels and legs
Turn both leveler legs to the same height. Put wheels in
the required position determined from "Dishwasher
Height Adjustment Chart". (To change wheel position,
use a flat bladed screwdriver to pop out the wheel, then
snap into the new position.)
Number of turns
on front leg
All the way up
1 10
2 5
3 0
3
2
1