Pioneer SX-319V-K Service Manual page 34

1
A
[3] The unit's operation when a error is detected
[Purpose]
• The unit's operation when a DC/OVER/TEMP error is detected is described here.
• How to cancel the status after detection of a DC error is described here, because no key input will be
accepted after a DC error detection.
[Basic operations]
3.1 DC (AMP is abnormality) error detection
Key Operation
B
(Normal display)
(DC detection)
(Auto)
(RECEIVER POWER OFF)
*1, *2
3.2 OVERLOAD (overcurrent) error detection
Key Operation
C (Normal display)
(OVERLOAD detection)
(Auto)
(RECEIVER POWER OFF)
*1
3.3 TEMP (AMP overheat) error detection
Key Operation
(Normal display)
D
(TEMP detection)
(Auto)
(RECEIVER POWER OFF)
*1
*1 The time required for the unit to be shut off after an error is detected depends on the circuit configuration.
*2 If the unit is automatically shut off after a DC error is detected, no key input will be accepted afterward.
(The power will not be turned ON.)
To turn it on again, see "3.4 How to cancel the status after detection of a DC error" below.
A key input will not be inhibited after an OVERLOAD/TEMP error is detected. (The unit can be turned ON.)
3.4 How to cancel the status after detection of the DC error
E
Key Operation
(STANDBY state)
[ADVANCED SURROUND]
+ [STANDBY/ON]
(press and hold the keys
for 2 seconds.)
(Normal display)
[Detailed explanations]
F
34
1
2
FL Display
FL Display
FL Display
FL Display
Simultaneously holding the [ADVANCD SURROUND] and [STANDBY/ON] keys on the
front panel pressed for 2 seconds will cancel Key Input Inhibition mode after a DC error
detection and turn the unit ON.
SX-319V-K
2
3
Time (sec.) Description of Indications
usually
Normal display
Time (sec.) Description of Indications
usually
Normal display
Time (sec.) Description of Indications
usually
Normal display
Time (sec.) Description of Indications
usually
Normal display
3
4
4