Safety Instructions - Electrolux EVD14900 Instructions Manual

4 www.electrolux.com

2. SAFETY INSTRUCTIONS

2.1 Installation
CAUTION!
The appliance must be installed
by qualified personnel only
• Remove the packaging material.
• Do not install or use the appliance if
damaged.
• Comply with the instructions supplied
with the appliance.
• Always pay attention when moving the
appliance. Always wear safety gloves.
• Do not turn the appliance upside down
or tilt it! This may cause oil to leak from
the pump and damage the equipment.
• Respect the minimum distance from
other appliances.
• Make sure the appliance is installed
and secured to a fixed structure.
• The sides of the appliance must be
adjacent to other equipment or units
having the same height.
2.2 Electrical connection
CAUTION!
Risk of fire and electric shock.
• All the electrical connections must be
made by a qualified electrician.
• The appliance must be earthed.
• Make sure that all the electrical data
shown on the data plate correspond
to those of the system. Otherwise,
contact an electrician.
• Always use an electrical outlet with a
correctly installed protective contact.
• Do not use multi-plug adapters or
extension cables.
• Make sure not to damage the mains
plug and the mains cable. If the power
cable must be replaced, this should be
carried out by our Assistance Centre.
www.markabolt.hu
• Shock protection devices must be
• Connect the mains plug to the mains
• Do not connect the mains plug if the
• Do not pull the mains cable to
• Use only suitable isolation devices:
• The electric system must be equipped
• This appliance complies with the EEC
fastened in such a way that they
cannot be removed without tools.
socket only once installation has been
completed.
mains socket is loose.
disconnect the appliance. Pull only the
mains plug.
circuit breakers, fuses (screw type
fuses must be removed from the fuse
holder), earth fault current releases
and relays.
with an isolation device that allows
you to disconnect the appliance from
the mains at every pole. The isolation
device must have a contact opening
width of a minimum 3 mm.
directives.