2.4
Installation of Modules
Install the modules.
1.
Installing a battery
The connector plug of the Q6BAT is disconnected from the jack of the CPU module before shipment. To use the battery,
connect the connector, following the procedure below.
1. Open the battery cover located on the bottom of the CPU module.
2. Check that the Q6BAT (1) is correctly installed.
3. Check the direction and securely insert the connector plug of the Q6BAT (2) to the jack (3) of the CPU module.
4. Close the battery cover.
2.
Inserting an extended SRAM cassette and a SD memory card
Since the example system does not use an extended SRAM cassette and a SD memory card, the insertion/removal
procedures are omitted in this document.
Refer to MELSEC iQ-R CPU Module User's Manual (Startup) for details.
3.
Installing a module
Install each module to the main base unit.
Refer to MELSEC iQ-R Module Configuration Manual for details.
2 MODULE STARTUP
16
2.4 Installation of Modules
View video: