Seconique NEPTUNE TRIPLE SLEEPER Assembly Instructions Manual

SEC/WG/09/17/DC2
WBF 04615
NEPTUNE TRIPLE SLEEPER
ASSEMBLY INSTRUCTIONS
IMPORTANT
FOR DOMESTIC USE ONLY
PLEASE READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY
RETAIN FOR FUTURE REFERENCE
CARE AND MAINTENANCE
WARNING "High beds and the upper bed of bunk beds are not suitable for children under the age of
six years due to the risk of injury from falls";
WARNING "Bunk beds and high beds can present a serious risk of injury from strangulation if not used
correctly. Never attach or hang items to any part of the bunk bed that are not designed to be used with
the bed, for example, but not limited to ropes, strings, cords, hooks, belts and bags";
WARNING "Children can become trapped between the bed and the wall, a roof pitch, the ceiling,
adjoining pieces of furniture (e.g. cupboards) and the like. To avoid risk of serious injury the distance
between the top safety barrier and the adjoining structure shall not exceed 75mm or shall be more than
230mm";
WARNING Do not use the bunk bed/high bed if any structural part is broken or missing;
The recommended mattress size for this bunk bed is 1900mm x 915mm x 150mm
The maximum mattress height is 160mm.
The maximum mattress height is clearly marked on the bunk bed and MUST NOT BE EXCEEDED.
Depending on the amount of use this product receives it may be necessary to tighten up the fixings from
time to time, this is completely normal for all flat pack furniture. DO NOT OVER TIGHTEN FIXINGS.
Do not for any reason use a power tool to assemble this product.
Two persons are required to assemble this bunk bed.
Assemble as close to its final position as possible.
Assemble on a soft clean surface.
For cleaning you may use a damp cloth (not wet).
The room in which the bed is positioned should be ventilated to prevent mould in and around the bed.
This bunk bed is manufactured to conform to BS EN 747:2012+A1:2015
PAGE 1