Table of Contents
Advertisement
If You Need Assistance
Or Service
This section is designed to help you save the cost of a service call. When calling our Con-
sumer Assistance
Center for help or calling for service, please provide a detailed description
of the problem, your appliance's complete model and serial numbers and the purchase date.
(See page 2.) This information will help us respond properly to your request.
1. Before
calling
for assistance
. . .
Please check the chart below for problems you can fix. It could save you the cost of a service
call.
PROBLEM
Dishwasher does not
run or stops during a
cycle
CHECK THE FOLLOWING
Is the door tightly closed and securely latched7
Has the cycle been set correctly? See page 6.
Has a household fuse or circuit breaker blown or tripped?
If the motor has stopped because of an overload, it will auto-
matically reset itself within a few minutes. If the motor does not
start, call for service.
Is the water supply turned on?
Is the dishwasher
wired into a live circuit with the proper
vottage?
Dishwasher seems to
The dishwasher
will run longer while heating the water. This is
run too long
normal for lower incoming water temperatures.
See page 10.
Dishwasher will not fill
Is overfill protector stuck in "up" position? Overfill protector
should move up and down freely. Press down to release.
Water remains in
dishwasher
Wait for the cycle to finish. A small amount of water remaining
is normal.
Detergent remains in
covered section of
dispenser
Dishes are not as dry
as you expected
Grinding, grating,
crunching or buzzing
sounds
Check the drain air gap (if installed). If it is clogged, follow the
manufacturer's
cleaning instructions.
Has the cycle completed?
Is the detergent fresh and dry without lumps?
Is the bottom rack in backwards? The rack bumpers should
face the door.
Is the rinse agent dispenser empty? Using a rinse agent greatly
improves drying. See pages 13 and 14.
Do not use Air Dry option on the next load. See page 11.
Has a hard object entered the POWER CLEANTM module?
The sound should stop when the object is ground up.
continued on next page
25
Advertisement
Table of Contents
