AEG QuickSteam DBS3340 Instruction Book page 9

TROUBLESHOOTING
PROBLEM
Soleplate is not heating even though
iron is turned on.
Iron does not produce steam.
Steam jet and vertical steam jet
function does not work.
Water leaks from the soleplate during
ironing.
Flakes and impurities come out of the
soleplate during ironing.
Water leaks from the soleplate while
the iron is cooling down or after it has
been stored.
Brown streaks come out of the
soleplate while ironing and stain the
linen.
DISPOSAL
This symbol on the product indicates that this product contains a battery which shall not be disposed with
normal household waste.
This symbol on the product or on its packaging indicates that the product may not be treated as household
waste. To recycle your product, please take it to an official collection point or to an AEG service center that can
remove and recycle the battery and electric parts in a safe and professional way. Follow your country's rules for
the separate collection of electrical products and rechargeable batteries.
AEG reserves the right to change products, information and specifications without notice.
www.aeg.com
DBS3340_SteamStation_AEG_NO-FARSI.indd 9
POSSIBLE CAUSE
Connection problem
Temperature control is in MIN position. Select adequate temperature.
Not enough water in tank.
Steam control is selected in non-steam
position.
Selected temperature is lower than
that specified to use with steam.
Steam jet function was used very
frequently within a short period.
Iron is not hot enough.
The iron is not hot enough.
You have used hard water, which has
caused scale flakes to develop in the
water tank.
The iron has been put in horizontal
position while there is still water in the
water tank.
You have used chemical descaling
agents.
Fabric fibres have accumulated in the
holes of the soleplate and are burning.
Fabrics might not be properly rinsed
or the garments are new and have not
been washed before ironing.
SOLUTION
Check main power supply cable, plug
and outlet.
Fill water tank (see "Getting started").
Set steam control between positions of
minimum steam and maximum steam.
(see "Ironing chart")
Increase temperature to at least
Put iron on horizontal position and wait
before using steam jet function.
Adjust the proper temperature to steam
ironing (up to ). Put iron in vertical
position and wait until temperature
indicator light turns off.
Set the temperature dial to a
temperature
( to maximum) suitable for steam
ironing. Put the iron on its heel and wait
until the light has gone out before you
start ironing.
Press and hold the steam button for
about one minute to get steam. Then
hold one more minute in order to clean
the steam generating system.
Iron an old towel, to ensure that
any residues inside the iron are not
transferred to the laundry.
Empty the water tank and set the steam
control to position off before storing
the iron.
Do not use any descaling agents.
Clean the soleplate with a damp soft
cloth.
Please rinse the laundry properly again.
GB
DE
AR
ES
FR
GR
.
IT
NL
PT
9
2017-07-06 14:17:53