Troubleshooting - Philips AC2889 User Manual

Hide thumbs Also See for AC2889:
Table of Contents

Advertisement

8 Troubleshooting

This chapter summarizes the most common problems you could encounter with the air
purifier. If you are unable to solve the problem with the information below, contact the
Consumer Care Center in your country.
Problem
The air purifier
does not work
even though it is
plugged into the
wall outlet and
switched on.
The air purifier
does not work
even though it is
switched on.
The air purifier
accidentally
powers off.
The airflow that
comes out of
the air outlet
is significantly
weaker than
before.
The air quality
does not improve,
even though the
air purifier has
been operating
for a long time.
The color of the
air quality light
always stays the
same.
Possible solution
The timer is set to a specific time interval. Reset or turn off
the timer.
Try a different electrical outlet or check the wall switch.
The filter alert status is displaying the filter code. Replace
the corresponding filter and reset the filter lifetime counter
(see chapter "Replacing the filters").
If the problem persists, visit www.philips.com/support
or contact the Consumer Care Center in your country for
assistance.
The filter replacement indicator has been on continuously
but you have not replaced the corresponding filter, and the
air purifier is now locked. In this case, replace the filter and
reset the filter lifetime counter.
The air purifier restarts automatically and goes to the
previous mode when the power resumes.
The pre-filter is dirty. Clean the pre-filter (see chapter
"Cleaning").
One of the filters has not been placed in the air purifier
or a filter is not placed properly. Make sure that all filters
are properly installed in the following order, starting with
the innermost filter: 1) NanoProtect HEPA filter (FY2422);
2) NanoProtect Active Carbon filter (FY2420); 3) pre-filter.
The air quality sensor is wet. Make sure that the air quality
sensor is clean and dry (see chapter "Cleaning").
The air quality sensor is dirty. Clean the air quality sensor
(see chapter "Cleaning").
EN
15

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents