LG ESS HB 10.0 Installation Manual page 61

CAUTION
Please turn on or off the switch by pushing the middle of the bar. It is forbidden to push either end
side of the bar. Any improper use could damage the product.
※ Connect/disconnect the wire to connector sequence
E Close the wiring box cover.
F Fasten the two screws (marked position) at the
bottom of wiring box cover.
A Make sure the circuit breaker off and the
disconnect switch off.
If removing power cables, check for voltage at
power cable terminal
B To remove one of the wires from its terminal,
insert a small screwdriver into the rectangular
hole above the terminal.
C Apply slight pressure to the screwdriver and at
the same time pull out the wire.
Installation
25
3