Sony CDX-G1200U Service Manual page 4

CDX-G1200U/G1201U/G1202U/G1280UM
MODEL IDENTIFICATION
Distinguish by Part No. on the bottom side of the main unit.
– Bottom view –
(US, CND, AEP, UK, EA, HK and KR models)
Part No.
Model Number Label
– Bottom view –
(E, AR, IND and AUS models)
Part No.
Model Number Label
Part No.
4-596-372-0[] G1200U: AEP, UK, HK models (EUR)
4-596-373-0[] G1201U: AEP, UK models (EUR)
4-596-374-0[] G1202U: AEP, UK models (EUR)
4-596-375-0[] G1200U: E, AUS models (E)
4-596-376-0[] G1200U: AR model (AR)
4-596-377-0[] G1200U: IND model (IN)
4-596-378-0[] G1280UM: IND model (IN)
4-596-379-0[] G1200U: EA model (EA)
4-596-380-0[] G1200U: KR model (KR)
4-596-381-0[] G1201U: E model (E)
4-596-382-0[] G1201U: EA model (EA)
4-596-383-0[] G1202U: EA model (EA)
4-596-384-0[] G1201U: KR model (KR)
4-599-961-0[] G1200U: US, CND models (UC)
4
Destination
DESTINATION SETTING METHOD
When the complete MAIN board or system controller (IC501) is
replaced, the destination setting is necessary.
1. Destination Setting
Set destination according to the procedure below.
1-1. Setting the Destination Code
1. In the state of source off (the clock is displayed on the liquid
crystal display), enter the test mode by pressing the buttons in
order of the [ 4] t [5] t [
button for two seconds).
Clock display
2. In the state in which the software main version is displayed on
the liquid crystal display (refer to the following fi gure), enter
the destination setting mode by pressing the buttons in order
of the [ ] t [
> M m .
pressing the buttons on the remote commander in order of the
[ b ] t [ B ] t [ENTER].
(Displayed characters/values in the following fi gure are ex-
ample)
Software main version
3. Input the alphanumeric character of 6 digits displayed on the
liquid crystal display, and execute the destination setting.
Note 1: The displayed contents of the following fi gure is an example. The
destination code is different depending on the destination of the
product.
Note 2: Refer to the following "1-3. Entering the Destination Code" for
operation method.
Destination code
4. The resetting operation is executed by pressing the [ OFF
SRC] button for 1 second after the setting ends, and the unit
returns to the normal condition.
Display after reset
6] (press only the [
u u
] t [PUSH ENTER/MENU] or
6 digits
6]