Whirlpool LE5320XT, LE5530XS, LE5600XS, LE5650XM, LE5700XS, E5705XP, LE6055XS, LG5321XT, LG5531XS, LG5601XS, LG5651XM, LG5701XS, LG5706XP, Use And Care Manual page 13

llomove-0
bdorm opmlng
top
Wire dip-
bold8 door
l wlIoh wtrcm
Vlew
D
tfyokuchyefk'&sandhamaWIfront
pfld#-fNlltpcuwl~kl~
1. Unplug the power supply cord or turn
off the electrbal power.
2. Cpen lint screen lb. Remove two
screws in lint screen area.
3. Open top by pulling forward and up
at each front corner (see view A).
Rest raised top against wall behind
dryer (top
is
hinged at
rear).
4. Remove two internal screws from
front panel flanges (near top front
comers). Lii front panel slightly,
lifting off bwer clips (see view B).
Slowly pull front panel forward,
disengaging panel from drum. (Drum
will drop slightly.)
5. Move front panel aside and rest edge
against side of dryer. Avoid discon-
necting wire clips (see view C) or
damaging wires.
6. Remove lint from area shown in -gas
dryer illustration on page 12 with soft
brush or vacuum deaner. Avoid
damaging wires, funnel or igniter.
7. Reassemble in reverse order. Before
closing the top, check the following:
- Drum seal must be flared out (see
view D)
and
properly positioned
against panel at back of drum.
Rotate drum counterclockwise one
full
turn
to chedc drum seal.
- Belt should be centered and tight
on dryer drum.
- wire clips which hold the door
switch wires must be anchored in
slot in top of front panel (see
view C) and along top edge of side
panel. Door wires must not touch
drum when dryer ls operating.
See Warnlng, page 12.
8. Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
9. Reconnect power and level dryer
again (if necessary).
NOTE:
Call Consumer Assistance at
1-800-253-l 301 for assistance or
more information.
13