Whirlpool LE4440XW Use And Care Manual page 12

Caring For Your Dryer
Contlnued
Remove screws
before openlng top
II
VIewA
4.
Drum eeel Side panel
Front panel
wlre dip
wire dlp-
holds door
4 s VIewE
View D
lfyowdfysrlsgasandhasafullfmnt
paneJrmovefrmtp.melasfolkwsz
1.
Unplug the power supply cord or turn
2.
3.
5.
6.
7.
8.
9.
off the~electrical power.
Remove lint screen. Remove two
screws in lint screen area.
Open top by pulling forward and up
at each lront Mrner (see view A).
Rest raised top against wall behind
dryer (top is hinged at rear).
Remove two internal screws from
front panel flanges (near top front
comers). Lift front panel slightly,
lifting off lower clips (see view B).
Slowly pull front panel forward,
disengaging panel from drum.
(Drum will drop slightly.)
Move front panel aside and rest edge
against side of dryer. Avoid discon-
necting wire clips (see view C) or
damaging wires.
Remove lint from area shown in 'gas
dryer illustration on page 11 with soft
brush or vacuum deaner. Avoid
damaging wires, funnel or igniter.
Reassemble in reverse order. Before
closing the top, check the following:
- Drum seal must be flared out (see
view D) and properly positioned
against panel at bade of drum.
Rotate drum countercbdkse one
full turn to chedc drum seal.
- Belt should be centered and tight
on dryer drum.
- wire clips which hold the door
switch wires must be anchored in
slot in top of front panel (see
view C) and along top edge of side
panel. Door wires must not touch
drum when dryer is operating.
See Wsrnlng, page 11.
Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
Reconnect power and level dryer
again (if necessary).
NOTE: Call Consumer Assistance at
1-800-253-l 301 for assistance or
more information.