Connect The Printer To Your Network; Connect A Usb Device - Honeywell PC42t User Manual

Chapter 2 — Connect the Printer

Connect the Printer to Your Network

If your printer has a factory-installed optional Ethernet port, you can
connect the printer to your network. By default, the printer is configured
to obtain an IP address through DHCP. If your network uses a different
method to assign IP addresses, you need to configure the IP address
assignment method by using your printer configuration software through
a USB or an optional serial connection.
1 Turn on the printer.
2 Connect one end of the Ethernet cable to the printer and the other
3 Print a configuration label to find the IP address for the printer. For
4 Configure any necessary Ethernet settings through the printer web

Connect a USB Device

You can use the USB host interface port on the printer to connect
keyboards, bar code scanners, or a USB storage device.
1 If you are connecting a USB storage device, make sure the device
2 Connect the device to the USB host port.
24
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
end to the network.
help, see "About Test Labels" on page 19.
It takes approximately 10 seconds after the printer LED turns steady
green to obtain an IP address. If the configuration label prints an IP
address of 0.0.0.0, wait 10 seconds and print another label.
page or PrintSet.
has a single partition and is formatted as FAT16 or FAT32.
V10 CONSUMIBLES S.L.
PC42t Desktop Printer User Guide