Using Your Dryer; Starting Your Dryer - Whirlpool 8280527 Use & Care Manual

4.
(OPTIONAL STEP) Some dryers have an On/Off
FINISH GUARD ® selector, or an Off/30 min. or
90 min. FINISH GUARD
features protect your clothes from wrinkling when
you do not remove them from the dryer as soon
as it stops.
•
Set the FINISH GUARD selector to On to
tumble the load without heat every few minutes
up to 45 minutes after the drying cycle ends.
•
The FINISH GUARD Plus selector lets you
choose up to 30 or 90 minutes of periodic
unheated tumble time after the drying cycle
ends.
•
A signal will sound every few minutes while
FINISH GUARD (FINISH GUARD Plus) is
running if the Cycle Signal (End of Cycle
Signal) feature is set to On. The signal and
cycle end when you open the dryer door.
•
Set the FINISH GUARD (FINISH GUARD Plus)
selector to Off if you do not want to run this
feature.
NOTE: Some dryers have a FINISH GUARD feature
that cannot be turned On or Off. See page 13.
5.
(OPTIONAL STEP) If your dryer has a Cycle
Signal (End of Cycle Signal) selector, set the
selector to On if you want the dryer to sound
a signal when a cycle is finished.
•
The signal is helpful when you are drying
permanent press, synthetics, and other items
that should be removed from the dryer as
soon as it stops.
•
On some models, the End of Cycle Signal is
part of the Start (Push to Start) button.
•
On some models, the signal volume can be
adjusted from Softer to Louder.
® Plus selector. These
6.
Push the Start (Push to Start) button.
NOTE: Your dryer stops automatically when a
cycle ends.
Stopping and restarting your dryer
You can stop your dryer anytime during a cycle.
To stop your dryer:
Open the dryer door or turn the Cycle Control knob
to Off.
NOTE: The Cycle Control knob should point to an
Off area when the dryer is not in use.
To restart your dryer:
Close the door, select a new cycle and temperature
(if desired), and push the Start (Push to Start)
button.

USING YOUR DRYER

9