Emerson Copeland EazyCool ZX Series Application Manuallines page 65

Parameter Parameter description
A19 Probe 7 configuration
C05 Compressor regulation probe selection
G01 Case temperature probe selection
G56 Use the liquid line solenoid
S07
C01 Compressor cut in pressure setpoint
C02 Compressor cut out pressure setpoint
G02 Cut-out temperature
G03 Positive differential defines upper cut-in temperature
Parameter Parameter description
A19 Probe 7 configuration
G12 Defrost probe selection
G23 Defrost interval mode
S05
G18 interval between defrost cycles
G19 Maximum length for defrost
G21 Defrost termination temperature
G26
C6.1.6/0613-0915/E
Pumpdown with temperature sensor
Relay Output 4
Defrost with time intervals
Relay Output 2
Drip time
Factory setting
NU = Not used
SUP = Suction pressure probe
NU = Not used
No
NU = Not used
4 bar rel
2 bar rel
+2°C
1K
Factory setting
NU = Not used
NU = Not used
NU = Not used
NU = Not used
4
20
10
1
Required setting
TMT = Thermostat temperature
CST = Case temperature
TMT = Thermostat temperature
Yes
LLS = Liquid line solenoid
Adjust to application requirements
Adjust to application requirements
Adjust to application requirements
Adjust to application requirements
Required setting
EPT = Evaporator temperature
EPT = Evaporator temperature
IN - by time (G18)
DEF = Defrost
Adjust to application requirements
Adjust to application requirements
Adjust to application requirements
Adjust to application requirements
60