Table of Contents
Advertisement
Available languages
Available languages
Complete Installation
NOTE: Handle air conditioner with care.
1. Make sure the free end of the ground wire is outside of the
cabinet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
2. Insert air conditioner into cabinet.
WARNING
Electrical Shock Hazard
Connect green ground wire to ground screw.
Failure to do so can result in death or
electrical shock.
3. Connect green ground wire to cabinet base with ground
screw. Position ground wire pointing straight up. Put excess
ground wire between coil and air conditioner cabinet.
A
+
+
B
+
A. Green ground wire
B. Ground screw
4. Install foam seal in the gap between air conditioner base and
cabinet. Push foam seal in at the sides and trim any excess
material.
A
A. Foam seal
5. Remove the 2 front panel screws from air conditioner base.
6. Insert front tabs of front panel into top of cabinet and swing
front into place.
7. Attach bottom front of panel with front panel screws. Replace
control knobs (on some models).
NOTE: Route power supply cord through notch in front panel.
B
A
A. Front panel screws
B. Power supply cord notch
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
8. Plug into a grounded 3 prong outlet.
Page 9
Advertisement
Table of Contents
