Whirlpool 3QACM07XD2 Owner's Manual page 12

I
Installation procedure
1. Remove the front panel. Remove tape (if
any). Lift panel and take it off the cabinet.
5.
4. Slide the chassis out of the cabinet.
2. Remove the shipping brackets (2).
Remove the cabinet ground screw (1)
and disconnect the green and yellow
grounding wire.
3. Remove the rear shipping screws (2).
Install the drain plug and drain cup
(accessory parts) to rear of cabinet. Slide
drain cup down into rear support between
grooves in cup.
NOTE: Attach drain plug and drain cup
assemblies and attach hose before
sliding unit into cabinet.
Install
\
asket
Screws
Install Drain
Drain cup
,
PlW
6. Fix the cabinet to the support frame.
12