Condition Combination - Bosch VCU Manual

9 | Project Configuration
34 / 136
2. Define the condition channel, using the following configuration possibilities:
a)
b)
c)
d)
e)
a) Enter the name of the conditional channel.
b) Select the comparing mode:
– Constant: Compare a measurement channel with a constant value.
– Channel: Compare a measurement channel with a measurement channel.
– Range: Compare a measurement channel with a defined value range.
– Multiple: Compare a measurement channel with up to 5 constant values.
c) Depending on the chosen comparing mode, you can enter the following values:
– Constant: Choose the measurement channel or condition, the operator and enter the
value of the channel.
– Channel: Choose the measurement channel or condition, the operator and the meas-
urement channel or condition to be compared.
– Range: Choose the measurement channel or condition, the operator and define the
minium and maximum value.
– Multiple: Choose the measurement channel or condition, the operator and enter the
value of up to 5 constants.
d) Enter the minimal time to detect the signal of the measurement channel, to avoid high-
frequent switchovers.
e) Enter the time the signal of the measurement channel is delayed after its ending.
f) Choose the output setting of the result.
– Constant TRUE/FALSE: Result is as a constant with the value TRUE or FALSE.
– Blinking: Result is a blinking, if the condition is fulfilled.
– Pulse: Result is a short one-time pulse, if the condition is fulfilled.
– Toggling output: Result is a pulse that lasts until the next condition is fulfilled.
– Click 'Ok' when done. The conditional channel is displayed in the Vehicle Control Unit
VCU condition channel window.

9.4 Condition Combination

– Combination of several (up to 16) conditional channels for more complex calculations
– Logical results
Vehicle_Control_Unit_VCU_Manual
f)
Bosch Motorsport