Physical Interfaces Of The Compact Multi-Band Models; Table 8 Physical Interfaces Of The Compact Multi-Band Models Of The Nokia Fastmile 4G Receiver - Nokia FastMile 4G Product Overview

Nokia FastMile 4G Receiver Product Overview
Figure 11 Location of physical interfaces on the Compact mono-band and ABA models of the
Nokia FastMile 4G Receiver
8.2 Physical interfaces of the Compact multi-
Table
FastMile 4G Receiver.
Table 8 Physical interfaces of the Compact multi-band models of the Nokia
Interface
Ground point
Ethernet port
Status LED
Signal strength LEDs
Measurement button
(1 of 2)
Issue: 01 DRAFT
Ground point
Ethernet Cable
band models
8 describes the physical interfaces of Compact multi-band models of the Nokia
FastMile 4G Receiver
Description
Point for connecting to external ground
Located on the back of the unit; see Figure 12.
The Compact multi-band models have a female RJ 45 connector for attaching a
customer-supplied cat5e shielded Ethernet cable with standard pinouts that is a
maximum of 80 m (262 ft) in length; the same cable is also used for power (PoE as
per IEEE802.3 at type-2).
Located on the underside of the unit; see Figure 13.
Single multifunction LED that indicates status information for the Nokia FastMile 4G
Receiver.
Located on the top of the unit.
See section
multi-band models and information about its behavior.
The Compact multi-band models have a set of five LEDs that work together to indicate
the LTE signal strength detected by the Nokia FastMile 4G Receiver.
Located on the top of the unit.
See section
information about their behavior.
Button to activate the signal strength LEDs
Located on the side of the unit.
See section
information about using it to activate the signal strength LEDs.
3TG-00386-ABAA-TCZZA
SIM slot
Status Reset
LED button
10.1 for a figure showing the location of the status LED of the Compact
10.2 for a figure showing the location of the signal strength LEDs and
10.2 for a figure showing the location of the measurement button and
DRAFT
28797
Physical interfaces
47