Weider WESY96352 User Manual page 18

36. Attach the Press Bracket (94) to the Leg
Press Arm (96) with a 5/16" x 3" Bolt (75) and
a 5/16" Nylon Locknut (3).
Wrap the Leg Press Cable (99) around a 3 1/2"
Pulley (15). Attach the Pulley to the Press
Bracket (94) with the 3/8" x 2" Bolt (12) and a
3/8" Nylon Locknut (21).
Slide a 5/16" Flat Washer (8) onto a 5/16" x
2 3/4" Bolt (11). Insert the Bolt through the
lowest hole in the Rear Seat Frame (100)
from the indicated side. (Note: The three
holes are for cable adjustment.) Tighten a
5/16" Nylon Jam Nut (93) onto the Bolt. Slide
the end of the Leg Press Cable (99) onto the
end of the Bolt. Thread another 5/16" Nylon
Jam Nut onto the Bolt. Do not fully tighten
the second Jam Nut. There must be room
between the two Jam Nuts for the end of
the Cable to pivot.
37. Locate and open the parts bag labeled
"SEAT ASSEMBLY."
Insert a 1/4" x 2 1/2" Carriage Bolt (92)
through the center hole in a Seat Plate (37).
Attach the Seat Plate to the Rear Backrest
(85) with two 1/4" x 3/4" Screws (18).
Insert the 1/4" x 2 1/2" Carriage Bolt (92)
through the indicated hole in the Leg Press
Upright (56). Tighten a 1/4" Nylon Locknut (2)
with a 1/4" Flat Washer (10) onto the Carriage
Bolt. Attach the top of the Rear Backrest (85)
to the Leg Press Upright with a 1/4" x 2 1/2"
Screw (43) and a 1/4" Flat Washer (10).
38. Attach one end of a Seat (13) to the Rear
Seat Frame (100) with two 1/4" x 3/4" Screws
(18). Attach the other end of the Seat to the
Rear Seat Frame with a 1/4" Flat Washer (10)
and a 1/4" x 2 1/2" Screw (43).
36
11
100
37
56
18
10
43
2
38
18
96
12
3
8
94
99
15
21
93
85
37
92
13
18
10
43
100
75