Weider WESY96352 User Manual page 14

25. Locate the Low Cable (23). Route the Low
Cable under the 3 1/2" Low Pulley (76)
attached to the lower hole in the Press Frame
(17). Be sure that the end of the Cable with
the ball is on the indicated side of the
Press Frame and that the Cable is between
the Pulley and the crossbar on the Press
Frame. Tighten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (not shown).
26. Route the Low Cable (23) around the 3 1/2"
Pulley (15) attached to the lower hole in the
Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown. Tighten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (88).
27. Route the Low Cable (23) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown. Tighten the 3/8" Nylon
Locknut (21) and the 3/8" x 3 1/2" Bolt (not
shown).
28. Route the Low Cable (23) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown. Tighten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (88).
25
Crossbar
26
42
15
21
27
28
42
21
14
21
76
17
23
15
88
42
Inset shows view
from other side
23
23
15
21
66
17
23 15
23
88
15
42
Inset shows view
from other side
23
Ball
66
66