Part Identification Chart - Weider PLATINUM 600 User Manual

PART IDENTIFICATION CHART

See the drawings below to identify small parts used in assembly. The number in parentheses by each drawing is
the key number of the part, from the PART LIST in the center of this manual. Note: Some small parts may
have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached.
M10 Nylon Locknut (71)
3/8" Lock Washer (74)
#8 x 1/2" Screw (82)
#8 x 3/4" Screw (104)
3/8" x 1" Screw (100)
3/8" x 1 1/2" Tension Screw (106)
3/8" x 1 3/4" Button Bolt (25)
3/8" x 2 1/4" Screw (85)
3/8" x 2" Carriage Bolt (91)
1/2" Nylon Locknut (78)
5/16" Washer (76)
M12 Nylon Locknut (72)
3/8" Nylon Locknut (73)
3/8" SAE
Washer (75)
3/8" Nylon Jamnut (92)
5/16" Nylon Locknut (107)
M8 Flange Nut (47)
M12 x 58mm Button Bolt (81)
M12 x 62mm Button Bolt (80)
3/8" x 2 1/2" Button Bolt (96)
3/8" x 2 1/2" Bolt (94)
3/8" x 2 3/4" Bolt (93)
3/8" x 3" Bolt (87)
3/8" x 2 3/4" Carriage Bolt (88)
1/2" x 3" Carriage Bolt (79)
3/8" x 3 1/2" Bolt (90)
3/8" x 4" Bolt (86)
M8 x 114mm Axle (102)
3/8" x 6" Bolt (83)