Advertisement
Quick Links
Data, drawings, and other material
contained herein are proprietary to
Wegener Communications, Inc., and
may not be reproduced or duplicated in
any form without the prior permission
of Wegener Communications, Inc.
When ordering parts from Wegener
Communications, Inc., be sure to include
the equipment model number, equipment
serial number, and a description of the part.
In all correspondence with Wegener
Communications, Inc., regarding this
publication, please refer to Manual Number
800016-13 A.
First Edition:
August 2000
Installation/Operation Guide
UNITY RF Switch Option
WEGENER
COMMUNICATIONS
TECHNOLOGY PARK/JOHNS CREEK
11350 TECHNOLOGY CIRCLE
DULUTH, GEORGIA 30097-1502
(770) 814-4000 FAX (770) 623-0698
R
Advertisement
Summary of Contents for Wegener Unity RF Switch
- Page 1 Installation/Operation Guide UNITY RF Switch Option Data, drawings, and other material contained herein are proprietary to Wegener Communications, Inc., and may not be reproduced or duplicated in any form without the prior permission of Wegener Communications, Inc. When ordering parts from Wegener Communications, Inc., be sure to include...
-
Page 2: Tools Required
The Expansion Bus may also be labeled as the Relay Expansion Bus. If your unit has the Expansion Bus/tuner cable already installed, make sure there is a 3-connector cable in your kit. If there is not, contact Wegener Communications Customer Service (See rear cover for numbers.) before continuing this installation. - Page 3 B. INSTALL THE RF SWITCH Figure 1 (Page 5) and Figure 2 installation. 1. Remove the block-out plate from the Module where the switch is to be installed. These screws and holes will be used to mount the RF Switch in a later step. Use the #1 Philips Screwdriver for this.
-
Page 4: Operation
Page 4 C. SET RF SWITCH OPTIONS 1. Set Jumpers on the option card to the dotted position. When setting the jumpers, observe that there are three pins on each header. The jumper covers two of these pins and connects them together electrically. In one position Pin 2 (center pin) is connected to Pin 1, while in the other position Pin 2 is connected to Pin 3. - Page 5 Cable from RF Switch Out to Tuner In Rear UNITY4000 MOTHER BOARD Tuner Board RF Switch Expansion Front Figure 1. Typical Two-Connector-Cable Installation Cable from RF Switch Out to Tuner In Rear UNITY4000 MOTHER BOARD Tuner Board Red Line RF Switch Expansion Front Figure 2.
- Page 6 Page 6 SERVICE RETURN ADDRESS Service Department RMA# ________ Wegener Communications, Inc. 359 Curie Drive Alpharetta, GA 30005 SERVICE CONTACT NUMBERS AND ADDRESSES Voice: (770) 814-4057 FAX: (678) 624-0294 email: service@wegener.com 800016-13 Page 6 of 6...