Summary of Contents for Weed Eater TWIST-N-EDGE 530088738
Page 1
Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant. 1-800-554-6723 www.weedeater.com Operator’s Manual Manual del Operador Manuel de L’utilisateur For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product.
S Maintain unit according to recommended procedures. Keep cutting line at proper length. S Use only 0.080” (2 mm) diameter Poulan/ Weed Eater! brand line. Never use wire, rope, string, etc. S Install required shield properly before using the unit. Use only specified trimmer head;...
Page 3
S Stop engine and allow to cool before re- moving fuel cap. S Always store gasoline in a container ap- proved for flammable liquids. CUTTING SAFETY WARNING: Inspect the area before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by or become entangled in line.
2--cycle air-- cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand syn- thetic oil is recommended. (A 40:1 ratio is ob- tained by mixing 3.2 ounces of oil with 1 gallon of unleaded gasoline).
Page 5
Line in Notch Line exit hole S Wind the line evenly and tightly onto the spool. Wind in the direction of the arrow found on the spool. S Push the line into the notch, leaving 3 to 5 inches (7 -- 12 cm) unwound. S Insert the line into the the exit hole in the hub as shown in the illustration.
WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGA- TIONS: The U.S. Environmental Protection Agency/California Air Resources Board and POULAN/WEED EATER, DIVISION OF WCI OUTDOOR PRODUCTS are pleased to ex- plain the emissions control system warranty on your year 2000--2003 small off--road engine. In...
Page 7
PLACEMENT OF PARTS. Repair or replace- ment of any warranted part will be performed at no charge to the owner at an approved POU- LAN/WEED EATER servicing center. If you have any questions regarding your warranty rights and responsibilities, you should contact...