Page 1
Bien lire les instructions avant d’assembler l’outil. Tout défaut de le faire pourrait entraîner des blessures graves. WEED EATER 1030 Stevens Creek Road Augusta, GA 30907 545186762 Rev. 1 4/15/08 BRW Trademark Instruction Manual RTE112C WEED EATER 5855 Terry Fox Way...
SAFETY RULES WARNING: When using electric gar- dening appliances, basic safety precautions must always be followed to reduce the risk of fire, electric shock, and serious injury. Read and follow all instructions. SAFETY INFORMATION ON THE UNIT This power unit can be dangerous! Operator is responsible for following the warnings and instructions in this manual and on the unit.
Page 3
Never use wire, rope, string, etc. S Use specified trimmer spool. Make sure spool is properly installed and all parts are securely fastened. S Use only WEED EATER replacement parts and accessories as recommended. CUTTING SAFETY WARNING: Inspect area to be cut.
ASSEMBLY WARNING: If received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. TUBE ASSEMBLY Upper Locking Sleeve Assembly Wires Lower Locking Sleeve Assembly 1. Align upper tube groove with triangle on lower locking sleeve assembly.
Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing. 4. Twist the shield as illustrated until it snaps securely into place. Make sure the shield is assembled to the unit as shown in the illustration below and in the KNOW YOUR UNIT section of this manual.
Use only a voltage supply as specified on your unit. SELECT AN EXTENSION CORD Extension Cord Gauge Chart Length of Cord Gauge 18 Gauge 25 Ft. (7.5 m) 16 Gauge 50 Ft. (15 m) 16 Gauge 100 Ft. (30 m) Extension cords are available for this unit.
3. Clean entire surface of hub and spool. 4. Replace with a pre-wound spool or cut a length of 30 feet of 0.065″ (1.65 mm) di- ameter WEED EATER brand line. Use of heavier lines could overload and damage unit.
Page 8
as shown in the illustration. 9. Align the notch with the line exit hole. 10. Push the spool into the hub until it snaps into place. 11. Pull on the line extending outside the hub to release it from the notch; otherwise, the unit will not function properly.
Page 9
WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that require unit to be operating. TROUBLE CAUSE Trimmer head 1. Crowding trimmer line stops under a against material being load or does not cut.
WEED EATER brand electric or cordless product within two (2) years from the original date of purchase. If your WEED EATER brand electric or cordless product should fail within the limited warranty period, you may return it in complete condition,...