AEG HSM 5557 Instruction Manual page 43

4 On/Off switch
5 Taper lever and hair length adjuster
Accessories (no illustration)
4 X Comb attachments (lengths: 3 mm, 6 mm, 10 mm, 13 mm)
1 X Protective cap for shaving head
1 X Cleaning brush
1 X Hairdressing comb
Adjust Cutting Length
• First remove the protective cap from the shaving head.
• Fit a comb attachment according to your desired hair length.The
size of the hair length setting is displayed in the center of the
comb attachment.
• In order to fit a comb attachment, hold it with the teeth pointing
upwards. The labeling of the comb attachment should remain
visible on the back. Slide the shaving head onto the slots of the
attachment and push the attachment against the upper blade.
Cut Hair / Beard
• Select the cutting length.
• Connect the mains plug to a properly installed isolated ground
receptacle 230 V / 50 Hz.
• To turn the hair clipper on by sliding button (4) towards the "0"
icon. The switch position "I" (On) will be visible.
Note:
► Start by using the biggest comb attachment and cut your hair/
whisker step by step to the desired length.
► The taper lever (5) for adjusting the hair length provides your
device with additional flexibility. It allows you to cut hair without
changing the comb attachment. Within a range of 0 - 3 mm, the
hair length settings are infinitely variable.
► Adjusting the lever to an upwards position will provide for a
shorter hair length setting.
English
43