Table of Contents
Advertisement
Quick Links
WEBER
FLAME
LP Fireplace Owner's Guide
WARNING
If the information in this manual is not
followed exactly, a fi re or explosion may
result causing property damage, personal
injury or loss of life.
•
Do not store or use gasoline or other
fl ammable vapors and liquids in the
vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do
not use any phone in your building.
•
Immediately call your gas supplier from
a neighbor's phone.
•
Follow the gas supplier's instructions.
•
If you cannot reach the gas supplier, call
the fi re department.
- Installation and service must be performed
by a qualifi ed installer, service agency or
the gas supplier.
TM
#43028
WARNING
Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage. Read the
installation, operating and maintenance
instructions thoroughly before installing
or servicing this equipment.
WARNING: FOR OUTDOOR USE ONLY.
These instructions are to be retained by the
consumer for future reference.
43028 US 01/26/05
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Weber 43028
Summary of Contents for Weber 43028
- Page 1 Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. WARNING: FOR OUTDOOR USE ONLY. These instructions are to be retained by the consumer for future reference. WARNING 43028 US 01/26/05...
-
Page 2: Dangers And Warnings
Do not use a fl ame to check for gas leaks. Combustible materials should never be within 24 inches of the top, back or sides of your Weber Do not put a fi replace cover or anything fl ammable on, or beneath the fi replace. - Page 3 ® ©2003 The following trademarks are registered in the name of Weber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smoky Joe, Weber, Kettle Silhouette Confi guration, Botswana; Weber, Canada; Smoky Joe, Genesis, China; Kettle Silhouette Silhouette , Smoky Joe, Weber, One-Touch, Germany;...
-
Page 4: General Instructions
The cylinder connection must be compatible with the fi replace connection. STORAGE AND/OR NON USE • The gas must be turned off at the liquid propane cylinder when the Weber gas fi replace is not in use. • When the Weber ®... -
Page 5: Exploded View
EXPLODED VIEW... -
Page 6: Exploded View List
1. HOOD VENT 2. 1/4 - 20 X 1/2” CARRIAGE BOLT 3. SUPPORT BRACKET 4. HOSE AND REGULATOR 5. 1/4 - 20 X 1/2” NUT 6. LP TANK COVER 7. HOOD VENT SUPPORT 8. RAIN SHIELD 9. REAR PANEL 10. FUEL GAUGE 11. -
Page 7: Parts List
BASE - 1 TANK BRACKET - 1 TANK COVER - 1 REAR PANEL - 1 RAIN SHIELD - 3 HOOD VENT SUPPORT - 4 SUPPORT BRACKET - 3 PARTS LIST CERAMIC LOGS - 8 LAVA ROCKS HOOD VENT - 1 1/4 - 20 1/2”... - Page 8 (2 - Hand tighten only. ASSEMBLY (4 - Hand tighten only. (4 - Wrench tighten.
- Page 9 ASSEMBLY (2 - (4 - Hand tighten only. Hand tighten only. Warning text on panel faces outward.
- Page 10 ASSEMBLY (4 - Wrench tighten ALL nuts at this time. Empty lava rocks onto cardboard Do not obstruct ignition box. packing. Remove small debris. Do not empty bag of lava rocks directly into the fi replace. Doing so could cause the burner ports to clog.
-
Page 11: Important Lp Cylinder Information
NEVER store a spare LP Cylinder near this fi replace. NEVER fi ll the tank beyond 80% full. ® Your Weber gas fi replace is equipped for a cylinder supply system designed for vapor withdrawal. WARNING: Only use this fi replace outdoors in a well- ventilated area. - Page 12 If leak does not stop, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com Do not use the fi replace. Installation and repair should be done by a qualifi ed service person. The fi...
- Page 13 Note - All factory-made connections have been thoroughly checked for gas leaks. The burner has been fl ame-tested. As a safety precaution however, you should recheck all fi ttings for leaks before using your Weber place. Shipping and handling may loosen or damage a gas fi tting.
- Page 14 REFILLING THE LIQUID PROPANE CYLINDER We recommend that you refi ll the LP cylinder before it is completely empty. Removal of the LP cylinder Make sure hose is secured in retainer clip. Close cylinder valve (turn clockwise). Unscrew regulator coupling by turning counterclockwise, by hand only. Loosen cylinder lock wing nut and turn cylinder lock up out of the way.
- Page 15 This vent should be free of dirt, grease, bugs etc. • The gas connections supplied with your Weber designed and tested to meet 100% CSA and ANSI requirements. WARNING: Replacement LP tanks must match the regulator connection supplied with this fi...
- Page 16 fi replace. Replace using only Weber replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber. ® Remove rain shields. DANGER Failure to remove rain shields while igniting the fi...
-
Page 17: Manual Lighting
OPERATING INSTRUCTIONS MANUAL LIGHTING Remove the rain shields. DANGER Failure to remove rain shields while igniting the fi replace’s burners, or not waiting 5 minutes to allow the gas to clear if the fi replace does not light, may result in an explosive fl ame-up which can cause serious bodily injury or death. -
Page 18: Troubleshooting
HIGH. Flames do not ignite all burner holes. If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com TROUBLESHOOTING CHECK Inspect Spider / Insect Screen for pos- sible obstructions. -
Page 19: Annual Maintenance
Do not dislodge the spider/insect screen or enlarge the screen opening. If the spider/insect screen becomes damaged or cannot be cleaned, call Weber-Stephen Products Customer Service for replacement parts. MAIN BURNER CLEANING PROCEDURE Turn off the gas supply. -
Page 20: Main Burner Flame Pattern
MAIN BURNER FLAME PATTERN ® The Weber gas fi replace burner has been factory set for the correct air and gas mixture. A correct fl ame pattern is: • A yellow to light-orange fl ame An incorrect fl ame pattern is: •...
Need help?
Do you have a question about the 43028 and is the answer not in the manual?
Questions and answers