Safety Message To Operators Of Warning Light Equipment - Federal Signal Corporation Legend LGD Installation, Operation And Service Manual

Light bars
Table of Contents

Advertisement

Safety Message to Operators of Warning Light Equipment

People's lives depend on your safe use of our products. Listed below are some
important safety instructions and precautions you should follow.
• Do not attempt to activate or deactivate the light system control while driving in
a hazardous situation.
• Although your warning system is operating properly, it may not be completely
effective. People may not see or heed your warning signal. You must recognize
this fact and continue to drive cautiously.
• Situations may occur that obstruct your warning signal when natural and man-
made objects are between your vehicle and others, such as raising your hood or
trunk lid. If these situations occur, be especially careful.
• All effective sirens and horns produce loud sounds that may cause, in certain
situations, permanent hearing loss. You and your passengers should consider
taking appropriate safety precautions, such as wearing hearing protection.
• In order to be an effective warning device, this product produces bright light
that can be hazardous to your eyesight when viewed at a close range. Do not
stare directly into this lighting product at a close range, or permanent damage
to your eyesight may occur.
• The effectiveness of an interior mounted warning light depends on the clarity,
the tinting, and the angle of the glass it is being placed behind. Tinting, dirt,
defects, and steeply angled glass reduce the light output of the warning light.
This may reduce the effectiveness of the light as a warning signal. If your
vehicle has dirty, tinted, or steeply angled glass, use extra caution when driving
your vehicle or blocking the right of way with your vehicle.
• It is important that you fully understand how to safely operate this warning
system before use.
• Operate your vehicle and its light/sound system in accordance with your
department's Standard Operating Procedures.
• If a selected function does not perform properly or if any of the lamps remain
illuminated when the control is off, disconnect the power connector from the
control unit and contact the nearest service center.
• At the start of your shift, ensure that the entire warning light system and the
siren system are securely attached and operating properly.
Failure to follow these precautions may result in property damage, serious
injury, or death.
RETAIN AND REFER TO THIS MESSAGE
Installation, Operation, and Service Manual
Federal Signal www.fedsig.com
Safety Messages
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Legend lpx

Table of Contents