Advertisement
Quick Links
Advertisement
Related Manuals for Waves Digital Audio Effects Processor Doubler
Summary of Contents for Waves Digital Audio Effects Processor Doubler
- Page 1 Waves – Doubler Software Audio Processor User’s Guide Waves Doubler software guide page 1 of 6...
-
Page 2: Chapter 1 - Introduction And Overview
Chapter 1 – Introduction and Overview The Waves Doubler is a digital audio effects processor that replicates the incoming audio signal to another 2 or 4 voices. Each voice can be changed in Gain, Pan, Delay and Tune (Pitch). This achieves a wide range of colors of classic sounds that were popularized in the 1980’s by the use of digital... -
Page 3: Chapter 2 - Controls And Displays
100 cents equals a semitone. Use this control to set the voice’s detune in relation to the source. Slight detunes of 2 to 12 cents tend to sound relatively in tune while higher values begin to sound off and out of tune. Waves Doubler software guide page 3 of 6... - Page 4 The Shelf can boost all that beyond its corner frequency by up to 12dB. It can cut down much lower than that, down to -24dB, at which point the filter floor drops to make a cut filter. Waves Doubler software guide page 4 of 6...
- Page 5 This control is also automateable and can be used to reset the modulators to start at the exact position in selected cues of your session so they sound the same each time. Waves Doubler software guide page 5 of 6...
- Page 6 These counters will show the peak value until reset by clicking on the meter or counter. lights in red whenever output clipping occurred. Lower the output IGHT gain to avoid clipping. Click it to Reset. Waves Doubler software guide page 6 of 6...