Advertisement
1
Prepare the Reservoir:
Remove the reservoir from
Fill
base and fill with lukewarm
water.
Replace the reservoir onto
PRESSING DOWN
the base,
FIRMLY
to ensure full seating.
3
Prime Unit (First Time Use Only):
Prior to Very First Use of Unit, Prime Unit:
Set pressure control dial on base to high, point
the handle and tip into sink. Turn unit ON until
water flows from the handle, turn unit OFF.
High
QUICK START GUIDE
Replace
2
Select and Insert Tip:
Insert
4
Adjust Pressure and Pause Control:
For first time
users, adjust
pressure control
lowest
position.
to
Gradually increase
pressure as you prefer.
Low
Model WP-100
NO
Gap
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap
between control knob
and handle.
You can temporarily stop
water flow by pressing the
pause button on the
handle.
PAUSE
continued on back
Advertisement
Table of Contents
Related Manuals for Waterpik Technologies WP-100
Summary of Contents for Waterpik Technologies WP-100
- Page 1 Set pressure control dial on base to high, point the handle and tip into sink. Turn unit ON until water flows from the handle, turn unit OFF. High Model WP-100 Select and Insert Tip: Press tip firmly into Insert handle. When tip is...
- Page 2 Using your Waterpik Always place tip in mouth before turning unit on. Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink. Turn unit ON. Tip Removal: Push the tip eject button on the handle.
Need help?
Do you have a question about the WP-100 and is the answer not in the manual?
Questions and answers