Summary of Contents for Waterford Gas Hob
- Page 1 90cm GAS HOB 90cm GAS HOB OPERA TING & INST ALLA TION MANUAL OPERA TING & INST ALLA TION MANUAL Please read these instructions carefully before use Please read these instructions carefully before use...
-
Page 2: Table Of Contents
1. Introduction .............2 2. -
Page 3: Introduction
INTRODUCTION Dear Customer, Thank you for buying a Waterford Appliance. The quality of Waterford’s appliances is exceptional and immediately visible. Each one is designed to with- stand the most demanding kitchen environment. But its not just about sleek contemporary looks; every detail reflects Waterford Stanley’s long-standing design for total performance ethos. -
Page 4: Safety Instructions
Note: Before using the gas hob for the first time, read the operating manual carefully so that you can ensure safe operation and avoid damage to the hob. * The hob should only be used when it has been fully installed as outlined in the Installation Section. -
Page 5: Product Description
90cm Built-In Gas Hob with front commands Fig.5 Outer wok burner control knob Voltage : 230V ~ 50 Hz Max Burner Power: 11.8 kW Max Electrical Power: 0.6kW Dimensions: 900mm x 500mm x 50mm Gas Burner Technical Data GAS PRESSURE... -
Page 6: Installation Instructions
INSTALLATION INSTRUCTIONS The appliance must be installed in accordance with the regulations in force. All installation and adjust- ment operations must be carried out by a suitable qualified person. The manufacturer declines all liability for any direct or indirect damage if these regulations are not com- plied with. -
Page 7: Gas Connection
50 Fig. 10 VENTILATION The room where the gas hob is installed must be well ventilated to allow proper gas combustion. The air flow necessary must be no less than 2m for each kW of the appliance’s maximum rated power. -
Page 8: Hob Operation
When fitting an extraction hood over the appliance ensure that there is a permanent air vent to the room that allows adequate ventilation for both the hob and the hood. If the extraction hood is installed above the hob, a minimum distance of 750mm must be maintained between the top surface of the appliance and the bottom surface of the hood. -
Page 9: Wok Support
WOK SUPPORT This optional support was designed for concave base pans and are ideal for woks. See Fig 14. CLEANING In order to maintain the appearance of this hob, periodical cleaning is recommended. Wipe away any spills when they occur in order to prevent burned on deposits which can be difficult to remove. -
Page 10: Trouble Shooting
The following are a list of minor faults (with instructions on how to rectify them) that should be used by the operator in the event of the appliance not working prior to contacting a Service Engineer. PROBLEM 1. None of the rings lighting 2. -
Page 11: Warranty
We undertake to repair or replace, free of charge to you any part found to be faulty within the 2 year period from the date of purchase provided that:- The fault is, in our opinion, caused by defective workmanship, or material and not by accident, misuse, neglect or normal wear and tear.