2.3 Printer Parts
3. Setup
3.1 Setting Up the Printer
1. Place the printer on a flat, secure surface.
2. Make sure the power switch is off.
3. Connect the printer to the computer with the Centronics or USB cable.
4. Plug the power cord into the power supply connector at the rear of the
printer, and then plug the power cord into a properly grounded
receptable.
USB
Centronics
/ Parallel
Figure 1: Top front view
RS-23
Power
Figure 2: Back of Printer Parts
Ribbon Access Window
LED Indicator
Feed Button
Printer Top Cover
Top Cover Open Lever
Rear Paper Guides
Power Switch
2
Wall
Plug
Power Supply