Parts List; Cautions For Installation - JVC KD-DB52 Installation Manual

Hide thumbs Also See for KD-DB52:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Parts list

Parts list
A Film aerial (x1)
C Cable clamper (x3)

Cautions for installation

The film aerial A is exclusively for use inside the vehicle.
0
Do not install at the following locations:
0
- where it may block the driver's view.
- where it may obstruct the operation of safety devices such as air bags.
- on movable glass surfaces such as the rear hatch.
- at side of vehicle (e.g. door, front quarter window).
- on rear window.
Signal strength will weaken when installed at the following locations:
0
- on IR reflecting glass or locations covered with mirror type glass film.
- where it overlaps with genuine radio aerial (pattern).
- where it overlaps with window heating wires.
- on glass that blocks radio signals (e.g. IR reflecting glass, thermal insulation glass).
Do not bend or damage the film aerial A.
0
Do not apply any glass cleaner after pasting the film aerial A.
0
It may not be possible to install on certain vehicles.
0
Memo
   
Poor reception may occur:
- due to noise when the windscreen wiper, air conditioner, or motor is turned on.
- depending on the direction of the broadcast station with respect to the vehicle (aerial).
2
| ENGLISH
B Cable (3.5 m) with booster (x1)
D Cleaner (x1)
 

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kd-db42

Table of Contents