Installation Location; Installing The Indoor Unit - Mitsubishi Electric City Multi PKFY-P NAMU-E Series Installation Manual

2. Installation location

I PKFY-P06/P08NAMU-E
I PKFY-P12/P15NGMU-E
I PKFY-P18/P24/P30NFMU-E
Fig. 2-1

3. Installing the indoor unit

I PKFY-P06/P08NAMU-E
¡
£
Fig. 3-1
in.(mm)
Obstacle
Obstacle
Obstacle
™
¢
2.1. Installation location
• Mount the indoor unit on a wall strong enough to withstand the weight of the unit.
• Select a location so that air can be blown into all corners of the room.
• Avoid locations exposed to outside air.
• Select a location free of obstructions to the airflow in and out of the unit.
• Avoid locations exposed to steam or oil vapour.
• Avoid locations where combustible gas may leak, settle or be generated.
• Avoid installation near machines emitting high-frequency waves. (high-frequency
welders, etc.)
• Avoid locations where the airflow is directed at a fire alarm sensor. (Hot air could
trigger the alarm during the heating operation.)
• Avoid places where acidic solutions are frequently handled.
• Avoid places where sulphur-based or other sprays are frequently used.
2.2. Outline dimensions and service space (Fig. 2-1)
Select a proper position allowing the following clearances for installation and mainte-
nance.
Warning:
Mount the indoor unit on a wall strong enough to withstand the weight of the
unit.
∗ For PKFY-P06/08NAMU-E
Leave a service space of 2-1/8 in. (54 mm) or more for left or left-rear piping.
I PKFY-P18/P24/P30NFMU-E
Models
P18/P24NFMU-E 55-1/8 (1400)
P30NFMU-E 66-1/8 (1680)
3.1. Check the indoor unit accessories and parts (Fig. 3-1)
The indoor unit comes with the following parts and accessories:
I PKFY-P06/P08NAMU-E
PART NUMBER ACCESSORY
¡
Mount board
Tapping screw 4 × 35
™
£
Felt tape
¢
MA remote controller cable
in.(mm)
A B
Max. 9-27/32 (250)
Max. 5-29/32 (150)
QUANTITY LOCATION OF SETTING
1 Fix at the back of the unit
8
Set in packing
1
material
1
3