Before installing, verify that the electrical service agrees with the specifications on the rating plate located on the lower rear corner of the drawer warmer. If the supply and equipment requirements do not agree, do not proceed with the installation. Contact your Vulcan-Hart office immediately. UNPACKING This drawer warmer was inspected before leaving the factory.
LOCATION For efficient drawer warmer operation, choose a location that will provide easy loading and unloading without interfering with the final assembly of food orders. The installation location must allow adequate clearances for servicing and proper operation. INSTALLATION CODES AND STANDARDS The drawer warmer must be installed in accordance with: In the United States of America: 1.
WARNING: THE DRAWER WARMER AND ITS PARTS ARE HOT. BE VERY CAREFUL WHEN OPERATING, CLEANING OR SERVICING THE DRAWER WARMER. CONTROLS (Fig. 1) OPERATOR INDICATOR LIGHT FULL RANGE THERMOSTAT THERMOMETER (not shown) BEFORE FIRST USE WARNING: UNPLUG ELECTRICAL POWER SUPPLY BEFORE CLEANING. 1.
OPERATING DRAWER WARMER 1. Connect electric power supply. 2. Turn thermostat knob to desired setting. • Heating elements begin heating. • Operator indicator light is lit. 3. Thermometer will indicate the interior temperature of the drawer warmer. 4. Once desired temperature is reached, heating elements will cycle on and off. •...
To obtain service and parts information concerning this warmer, contact the Vulcan-Hart Service Agency in your area (refer to listing supplied with the warmer), or Vulcan-Hart Company Service Department at the address or phone number shown on the front cover of this manual.
Page 12
NOTES – 12 – FORM 31086 Rev. A (12-98) PRINTED IN U.S.A.
Need help?
Do you have a question about the VW1D ML-126508 and is the answer not in the manual?
Questions and answers