Correct Curled Media Via The Settings Editor - Canon Decurler Unit-C1 Operation Manual

Correct Curled Media via the Settings Editor

Correct Curled Media via the Settings Editor
Introduction
This procedure describes how to correct curled media via the Settings Editor. Make test prints on
the adjusted media to check the curl.
IMPORTANT
You are advised to make small increments to avoid paper jams.
NOTE
You can also correct curled media via the control panel.
NOTE
If the curl correction values are different for LEF and SEF, you must create two media in the
media catalog. One media for LEF and another media for SEF.
Procedure
1. Access the Settings Editor.
Open your web browser.
In the address bar, enter the IP address or host name of the PRISMAsync controller.
2. Select [Media].
3. In the [Media catalog], select the media you want to correct.
4. Select [Registration].
5. Define the correction in the section [Curl corrections].
When the media curls upward, adjust downward (+).
When the media curls downward, adjust upward (-).
6. Press [OK].
12 Chapter 2 - Use the decurler
NOTE
When you print a 1-sided job face up, select [Curl correction: output face up].
When you print a 1-sided job face down, select [Curl correction: output face
down].
When you print a 2-sided job, select [Curl correction: 2-sided output].
Canon Decurler Unit-C1