Prior To Connecting; After Connecting; Before First Use - KitchenAid 400010794234 Instructions For Use Manual

Prior to connecting

Check that the voltage on the rating plate
corresponds to the voltage in the home.
Ensure the appliance oven cavity is empty before
mounting.
Ensure that the appliance is not damaged. Check
that the microwave oven door closes firmly against
the door support and that the internal door seal is
not damaged. Empty the appliance oven and clean
the interior with a soft, damp cloth.
Do not operate this appliance if it has a damaged
mains cord, if it is not working properly, or if it has
been damaged or dropped. Do not immerse the
mains cord in water. Keep the cord away from hot
surfaces.

After connecting

The appliance can be operated only if the appliance
oven door is firmly closed.
The earthing of this appliance is compulsory. The
manufacturer will accept no responsibility for injury
to persons, animals or damage to objects arising
from the non-observance of this requirement.

Before first use

1. O , remove the accessories and
PEN THE DOOR
ensure the oven is empty
with tap water (no detergents) and
CONTAINER
then fill it to the "MAX" mark.
S
LIDE THE WATER CONTAINER
until it engages the contact point and sits firmly
in place.
2. R
UN THE CALIBRATION FUNCTION
screen instructions.
N
OTE
T responsible for filling and
HE WATERPUMP
draining the steam boiler is now activated. It will
initially sound louder during airpumping and
lower when water is filling the pump again.
RINSE THE WATER
into it's socket
and follow on
If the power cable is too short or damaged it must
be replaced. The power cable must only be
replaced by a qualified technician in compliance
with the manufacturer instruction and current
safety regulations. Contact an authorized service
center.
For installation to comply with current safety
regulations, an omnipolar disconnect switch with
minimum contact gap of 3 mm must be utilized.
The manufacturers are not liable for any problems
caused by the user's failure to observe these
instructions.
T
HIS IS NORMAL
A
FTER CALIBRATION
temperature and then wipe dry any damp areas
if present.
E
MPTY THE WATER CONTAINER
before further use.
9
and no concern for alarm.
, let the oven cool to room
and dry it off